Perkins 1106D Disassembly And Assembly page 79

SENR9983
Illustration 145
6. Install a suitable lifting device to the flywheel
housing. The flywheel housing can weigh 32 kg
(70.5 lb).
7. Use the lifting device to align the flywheel housing
(1) with Tooling (A). Install the flywheel housing to
the cylinder block.
8. Install the two M12 setscrews (2) and four M10
setscrews (3).
9. Remove Tooling (A). Install the remaining two M10
setscrews (3).
10. Tighten the setscrews (3) to a torque of 63 N·m
(46 lb ft).
11. Tighten the setscrews (2) to a torque of 78 N·m
(57.5 lb ft).
12. Check the alignment of the flywheel housing (1)
with the crankshaft. Refer to Testing and Adjusting
Manual, "Flywheel Housing - Inspect".
End By:
a. Install the flywheel. Refer to Disassembly and
Assembly Manual, "Flywheel - Install".
Installation Procedure (Wet Back
End Housing)
Table 30
Tool
A
B
Keep all parts clean from contaminants.
Contaminants may cause rapid wear and shortened
component life.
g01165544
1. Ensure that the flywheel housing is clean and free
from damage. If necessary, replace the flywheel
housing.
Illustration 146
2. Install a new oil seal (8) to the flywheel housing
(1).
Note: Press the oil seal into the flywheel housing
from the rear. Ensure that the front edge of the oil seal
is flush with the joint face of the flywheel housing .
3. Inspect the crankshaft rear seal (9) for leaks. If
there are any oil leaks, replace the crankshaft rear
seal. Refer to Disassembly and Assembly Manual,
"Crankshaft Rear Seal - Remove" and refer to
Disassembly and Assembly Manual, "Crankshaft
Rear Seal - Install".
Disassembly and Assembly Section
Required Tools
Part
Part Description
Number
Guide Stud
-
(M10 by 100 mm)
POWERPART
1861117
Universal Jointing
Compound
NOTICE
79
Qty
2
1
g01215183