Cylinder Head - Install - Perkins 1106D Disassembly And Assembly

118
Disassembly and Assembly Section
11. Gradually loosen the setscrews (14) in the reverse
numerical order to the tightening sequence. Refer
to the illustration 238.
Note: Follow the correct sequence in order to help
prevent distortion of the cylinder head.
12. Remove the setscrews (14) from the cylinder
head (15).
Illustration 239
Typical example
13. Attach a suitable lifting device (16) to the cylinder
head (15). Support the weight of the cylinder head.
The weight of the cylinder head is approximately
66 kg (145.5 lb).
Note: A spreader bar must be used in order to
distribute the weight of the cylinder head during the
lifting operation.
14. Use the suitable lifting device (16) to carefully lift
the cylinder head (15) off the cylinder block.
Note: Do not use a lever to separate the cylinder
head from the cylinder block. Take care not to
damage the machined surfaces of the cylinder head
during the removal procedure.
NOTICE
Place the cylinder head on a surface that will not
scratch the face of the cylinder head.
Illustration 240
Typical example
15. Remove the cylinder head gasket (17). Discard
the cylinder head gasket.
16. Note the position of the dowels (18) in the cylinder
block.
17. If necessary, remove the water temperature
regulator (1) from the cylinder head (15). Refer
to Disassembly and Assembly Manual, "Water
Temperature Regulator - Remove and Install".
18. If necessary, remove the inlet manifold (2) from
the cylinder head (15). Refer to Disassembly and
g01175427
Assembly Manual, "Inlet manifold - Remove and
Install".

Cylinder Head - Install

Installation Procedure
Table 54
Tool
A
B
C
Keep all parts clean from contaminants.
Contaminants may cause rapid wear and shortened
component life.
Required Tools
Part
Part Description
Number
Guide Stud
-
(M16 by 115mm)
21825607
Angle gauge
POWERPART
21820221
Rubber Grease
NOTICE
SENR9983
g01175687
i02296683
Qty
2
1
1