Crankshaft Rear Seal - Remove - Perkins 1106D Disassembly And Assembly

SENR9983
Illustration 128
3. Install a suitable lifting device to the flywheel (1).
The flywheel can weigh 70.6 kg (155.6 lb).
4. Install Tooling (A) in position (X) on the crankshaft.
5. Use the lifting device to position the flywheel (1)
onto Tooling (A).
6. If necessary, install the pilot bearing (3) and the
setscrews (2) to the flywheel (1).
7. Install setscrews (4) to the flywheel (1).
8. Remove Tooling (A) and install the remaining
setscrews (4) to the flywheel (1).
9. Use a suitable tool to prevent the flywheel from
rotating. Tighten the setscrews (2) and (4) to a
torque of 120 N·m (88 lb ft).
10. Remove the lifting device from the flywheel (1).
11. Check the run out of the flywheel. Refer to
Specifications Manual, "Flywheel" for further
information.
End By:
a. Install the electric starting motor. Refer to
Disassembly and Assembly Manual, "Electric
Starting Motor - Remove and Install".

Crankshaft Rear Seal - Remove

Removal Procedure
Table 25
Tool
A
Start By:
a. Remove the flywheel housing. Refer to
Disassembly and Assembly Manual, "Flywheel
Housing - Remove and Install".
g01159176
Keep all parts clean from contaminants.
Contaminants may cause rapid wear and shortened
component life.
Care must be taken to ensure that fluids are contained
during performance of inspection, maintenance, test-
ing, adjusting and repair of the product. Be prepared to
collect the fluid with suitable containers before open-
ing any compartment or disassembling any compo-
nent containing fluids.
Dispose of all fluids according to local regulations and
mandates.
Illustration 129
Disassembly and Assembly Section
Required Tools
Part
Part Description
Number
-
T40 Torx Socket
NOTICE
NOTICE
71
i02296656
Qty
1
g01174488