Crankshaft Timing Ring - Remove And Install - Perkins 1106D Disassembly And Assembly

SENR9983
End By:
a. If necessary, install the pistons and connecting
rods. Refer to Disassembly and Assembly Manual,
"Pistons and Connecting Rods - Install".
b. If necessary, install the cylinder head. Refer
to Disassembly and Assembly Manual,
"Cylinderhead - Install".
c. Install the rockershaft and pushrods. Refer to
Disassembly and Assembly, "Rockershaft and
Push Rods - Install".
d. Install the crankshaft rear seal. Refer to
Disassembly and Assembly Manual, "Crankshaft
Rear Seal - Install".
e. Install the front housing. Refer to Disassembly and
Assembly Manual, "Housing (Front) - Install".
f. Install the engine oil pump. Refer to Disassembly
and Assembly Manual, "Engine Oil Pump - Install".
Crankshaft Timing Ring -
Remove and Install
Removal Procedure
Start By:
a. If a crankshaft wear sleeve is installed to the
crankshaft, remove the crankshaft wear sleeve.
Refer to Disassembly and Assembly Manual,
"Crankshaft Wear Sleeve - Remove ".
b. Remove the crankshaft. Refer to Disassembly and
Assembly Manual, "Crankshaft - Remove ".
NOTICE
Keep all parts clean from contaminants.
Contaminants may cause rapid wear and shortened
component life.
Illustration 319
1. Support the crankshaft (1) on a suitable stand.
i02296702
2. Remove the three allen head screws (2) from the
crankshaft timing ring (3). Discard the allen head
screws.
3. Carefully remove the crankshaft timing ring (3)
from the crankshaft (1). Discard the crankshaft
timing ring.
Note: Ensure that the seal surface (4) of the
crankshaft is not damaged when the crankshaft
timing ring is removed.
Note: Do not remove the dowel (5) from the
crankshaft (1) unless the dowel is damaged.
Installation Procedure
Keep all parts clean from contaminants.
Contaminants may cause rapid wear and shortened
component life.
1. Ensure that the flange for the crankshaft timing
ring on the crankshaft is clean and free from
damage.
2. Support the crankshaft (1) on a suitable stand.
Disassembly and Assembly Section
NOTICE
155
g01159924