Rocker Shaft And Pushrod - Install - Perkins 1106D Disassembly And Assembly

114
Disassembly and Assembly Section
Illustration 227
2. If necessary, install the nuts (10) and the adjusters
(9) to the rocker arm assemblies (3) and (4). If
the original adjusters are reused, ensure that the
adjusters are installed in the original positions.
Illustration 228
3. Install the retaining clip (7) and the spring (8) to
the front end of the rocker shaft (5).
4. Lubricate the bores of the rocker arm assemblies
(3) and (4) and the rocker shaft (5) with clean
engine oil.
5. Install the rocker arm assembly (3) for number 1
inlet valve to the rocker shaft. Install the rocker
arm assembly (4) for number 1 exhaust valve to
the rocker shaft (5).
Note: The rocker arm assembly for the inlet valve is
longer than the rocker arm assembly for the exhaust
valve. Used components should be installed in the
original location.
6. If necessary, ensure that the locator (2) is correctly
seated in the pedestal (1). Ensure that the
counterbores for the holes in the rocker shaft (5)
are upward. Align the locator (2) with the hole to
the front of the rocker shaft (5). Install the pedestal
to the rocker shaft.
Improper assembly of parts that are spring loaded
can cause bodily injury.
To prevent possible injury, follow the established
assembly procedure and wear protective equip-
ment.
7. Install the spring (6) to the rocker shaft (5).
g01181179
8. Repeat Steps 5 to 7 in order to assemble the
remaining components to the rocker shaft (5).
End By:
a. Install the rocker shaft assembly. Refer to
Disassembly and Assembly Manual, "Rocker
Shaft and Pushrod - Install".
Rocker Shaft and Pushrod -
Install
Installation Procedure
Table 53
g01181801
Tool
A
Required Tools
Part
Part Description
Number
27610298
Angled Feeler Gauges
SENR9983
i02296681
Qty
1