Water Pump - Remove - Perkins 1106D Disassembly And Assembly

SENR9983
a. Install the components of the support bracket.
Ensure the correct location and orientation of
the bracket and the retaining clip.
b. Tighten the setscrews finger tight in order to
align the components of the support bracket.
c. Tighten the M10 setscrew to a torque of 44 N·m
(32.5 lb ft). Tighten the M8 fasteners to a torque
of 22 N·m (16 lb ft).
End By:
a. Install the engine oil pan. Refer to Disassembly
and Assembly Manual, "Engine Oil Pan - Install".

Water Pump - Remove

Removal Procedure
Start By:
a. Remove the fan and the fan pulley. Refer to
Disassembly and Assembly Manual, "Fan -
Remove and Install".
NOTICE
Keep all parts clean from contaminants.
Contaminants may cause rapid wear and shortened
component life.
NOTICE
Care must be taken to ensure that fluids are contained
during performance of inspection, maintenance, test-
ing, adjusting and repair of the product. Be prepared to
collect the fluid with suitable containers before open-
ing any compartment or disassembling any compo-
nent containing fluids.
Dispose of all fluids according to local regulations and
mandates.
1. Drain the coolant from the cooling system into a
suitable container for storage or disposal. Refer
to Operation and Maintenance Manual, "Cooling
System Coolant - Drain" for the correct procedure.
2. Loosen the hose clamps and remove the hose
(not shown) from the water pump inlet.
i02296130
Illustration 117
3. Remove the setscrews (4).
Note: The setscrews are three different lengths. Note
the positions of the different setscrews.
4. Remove the water pump (3) from the front cover
(1).
Note: If necessary, tap the water pump with a soft
hammer in order to loosen the water pump.
5. Remove the joint (2). Discard the joint.
6. If necessary, remove the cover (6) from the water
pump. Follow Steps 6.a through 6.c in order to
remove the cover.
a. Remove the two setscrews (7).
b. Remove the cover (6).
c. Remove the joint (5). Discard the joint.
Disassembly and Assembly Section
65
g01212581