Perkins 1106D Disassembly And Assembly page 59

SENR9983
Illustration 103
1. Ensure that the cooler matrix (19) is clean and
free from damage. Ensure that the spacer plate
(17) is clean and free from damage. Replace any
damaged components.
2. Position a new joint (18) onto the spacer plate
(17). Install the cooler matrix (19) to the spacer
plate.
3. Install the two setscrews (15) finger tight.
Illustration 104
4. Position the brackets (5) and (10) onto the
assembly of the oil cooler (6). Install the setscrews
(7).
Note: Ensure that brackets for the tube assemblies
are installed in the correct location and the correct
orientation. The setscrews are different lengths.
Ensure that the different setscrews are installed in
the correct location.
5. Install the joint (16) to the assembly of the oil
cooler (6). Push the setscrews (7) through the
holes in the joint.
Note: The holes in the joint have serrations that hold
the setscrews captive.
Assembly Procedure (Engine Oil
Cooler with a High Mounted Filter
Base)
g01174007
Illustration 105
1. Ensure that the cooler matrix (20) and the housing
(22) are clean and free from damage. Replace
any damaged components.
2. Install two new joints (21) to the cooler matrix (20).
3. Install the cooler matrix (20) to the housing (22).
4. Install the four nuts (23) to the assembly of the oil
cooler (6). Tighten the nuts to a torque of 22 N·m
(16 lb ft).
g01205285
Illustration 106
5. Install the setscrews (7) to the assembly of the
oil cooler (6).
Disassembly and Assembly Section
59
g01180538
g01205691