Electric Starting Motor - Remove And Install - Perkins 1106D Disassembly And Assembly

SENR9983
Electric Starting Motor -
Remove and Install
Removal Procedure
Accidental engine starting can cause injury or
death to personnel working on the equipment.
To avoid accidental engine starting, disconnect
the battery cable from the negative (−) battery ter-
minal. Completely tape all metal surfaces of the
disconnected battery cable end in order to prevent
contact with other metal surfaces which could ac-
tivate the engine electrical system.
Place a Do Not Operate tag at the Start/Stop switch
location to inform personnel that the equipment is
being worked on.
1. Disconnect the battery.
2. Place identification marks on the harness
assembly (not shown) that is connected to the
electric starting motor and the solenoid.
Illustration 361
Typical example
3. Disconnect the harness assembly from the electric
starting motor and the solenoid.
4. Remove the nuts (2) for the electric starting motor
(3).
5. Remove the electric starting motor (3).
6. If a joint is installed, remove the joint (4). Discard
i02296742
the joint.
7. If necessary, remove the studs (5) from the
flywheel housing (1).
Installation Procedure
Illustration 362
Typical example
1. If necessary, install the studs (5) into the flywheel
housing (1).
2. If necessary, install a new joint (4) onto the studs
in the flywheel housing (1).
3. Position the electric starting motor (3) onto the
studs in the flywheel housing (1).
4. Install the nuts (2).
Tighten M10 nuts to a torque of 44 ± 11 N·m
(32 ± 8 lb ft).
Tighten M12 nuts to a torque of 78 ± 19.5 N·m
(57 ± 14 lb ft).
5. Connect the harness assembly (not shown) to the
electric starting motor and the solenoid.
6. Connect the battery.
g01159172
Disassembly and Assembly Section
177
g01159172