Camshaft - Remove And Install - Perkins 1106D Disassembly And Assembly

SENR9983
b. Inspect the shank of the lifter for wear or
damage. Refer to Specifications Manual, "Lifter
Group" for more information.
c. Inspect the face of the lifter that runs on the
camshaft for visual wear or damage.
2. If the crankshaft is installed, use Tooling (A) to
rotate the crankshaft to access to the cylinder
block in order to install the appropriate lifters (1).
3. Lubricate the lifters (1) with clean engine oil.
Illustration 251
4. Use Tooling (B) to install the lifters (1) to the
cylinder block. Ensure that used lifters are
installed in the correct location.
Note: The lifters should be free to rotate.
5. Repeat Steps 1 and 4 in order to install the
remaining lifters.
End By:
a. Install the camshaft. Refer to Disassembly and
Assembly Manual, "Camshaft - Remove and
Install".
b. Install the engine oil pump. Refer to Disassembly
and Assembly Manual, "Engine Oil Pump - Install".

Camshaft - Remove and Install

Removal Procedure
Start By:
a. Remove the rockershaft and pushrods. Refer to
Disassembly and Assembly Manual, "Rocker shaft
and Pushrod - Remove".
b. Remove the front housing. Refer to Disassembly
and Assembly Manual, "Housing (Front) -
Remove".
Keep all parts clean from contaminants.
Contaminants may cause rapid wear and shortened
component life.
1. The engine should be mounted on a suitable
stand and placed in the inverted position.
g01167267
Illustration 252
Typical example
2. Remove the thrust washer (1) from the cylinder
block. Do not remove the dowel (2) from the
cylinder block unless the dowel is damaged.
Note: The thrust washer can have one or two slots
(X).
i02296685
Illustration 253
Do not damage the lobes or the bearings when the
camshaft is removed or installed.
3. Carefully remove the camshaft (3) from the
cylinder block.
Disassembly and Assembly Section
NOTICE
NOTICE
123
g01167327
g01167301