Akai FORCE User Manual page 90

Spring Reverb
Use this tab to apply and adjust the settings for the built-in Spring Reverb effect.
Parameter Description
Pre-Delay Length of time between dry signal and reverberated signal.
Time Length of reverb tail.
Mix Wet/dry amount of the reverb effect.
Diffusion Rate of increasing density of reverb reflections.
At lower settings, the sound of individual reflections is more present.
At higher settings, reflections are more uniform.
Width Stereo width of reverb signal. Higher values give wider stereo separation. 0–100%
Low Cut Center frequency for reverb signal low-cut filter.
90
Value Range
0 ms – 250 ms
1.0 – 10.0 s
0–100%
0–100%
20.0 Hz – 1.00 kHz