Akai FORCE User Manual page 209

When a Drum Track is selected, and Type is set to Pad:
Mixer: Off, Level, Pan, Pad Mute, Pad Solo, Send 1–4
Track:
Off
Tuning
Filter Cutoff
Filter Resonance
Filter Env Amount
Amp Env Attack
Amp Env Decay
Amp Env Release
Insert 1–4: Off, other available parameters depend on the effect
When a Keygroup Track is selected:
Mixer: Off, Volume, Pan, Mute, Solo, Send 1–4, Crossfader route, Cue bus enable
Track: Off, Master Semi Tune, Master Fine Tune
Insert 1–4: Off, other available parameters depending on the effect
When a Plugin Track is selected:
Mixer: Off, Volume, Pan, Mute, Solo, Send 1–4, Crossfader route, Cue bus enable
Track: Off, other available parameters depending on the plugin
Insert 1–4: Off, other available parameters depending on the effect
When a MIDI Track is selected:
MIDI CC: Standard MIDI control change assignments
When a CV Track is selected:
Mixer: Off, Mute, Solo
Track: Off, CV Out 1–4
When an Audio Track is selected:
Mixer: Off, Volume, Pan, Mute, Solo, Send 1–4
Insert 1–4: Off, other available parameters depending on the effect
To reset all changes, press the Reset button.
Amp Env Hold Layer Sample Pan (1–4) LFO to Filter
Amp Env Sustain Layer Semi Tune (1–4)
Filter Env Attack Layer Fine Tune (1–4)
Filter Env Hold Velocity to Start
Filter Env Decay Vel to Filter Attack
Filter Env Sustain Velocity to Env Amount LFO Sync
Filter Env Release Velocity to Filter
Layer Level (1–4) LFO to Pitch
LFO to Amp
LFO to Pan
LFO Wave
LFO Rate
Velocity to Pitch
Vel to Volume Attack
Velocity to Amp
Velocity to Pan
Layer Direction (1–4)
Layer Offset (1–4)
209