Table of Contents
Advertisement
To view, load, edit, or clear effects, tap the area under the Inserts
field. This usually appears in a channel strip (next to a level slider and
pan knob).
When viewing loaded effects, you will see this window:
To select an effect, use the field for each insert slot. A window
(described below) will appear.
To edit the parameters of a loaded effect, tap the pencil icon
next to the insert slot.
To clear the insert slot, tap the trash can icon next to it.
To enable or disable an effect slot, tap the On/Off button next
to it.
To disable all four effect slots, tap the All On/All Off button in the
upper-right corner. Tap it again to reactivate the previously active
effects.
When selecting an effect, you will see this window:
To move through the list, swipe up or down. Alternatively, use the
data dial or –/+ buttons.
To sort or unsort the effects by type or manufacturer, tap Type
or Manufacturer in the lower-left corner.
To load an effect, double-tap it. Alternatively, tap Select or the
data dial.
To cancel, tap Close or anywhere outside the list.
When you edit an effect, you will see this window:
To adjust a parameter, tap and drag its slider. Alternatively, use
the data dial or –/+ buttons. To make finer adjustments, double-
tap the pad and adjust the larger version of the slider that
appears.
Tip: Set the Knobs to screen mode to quickly adjust the
corresponding parameters.
To select another page of parameters, tap tabs at the bottom of
the screen.
To enable or disable the effect, tap the On/Off button in the
upper-right corner.
To edit parameters for another insert effect on the same pad,
track, etc., tap the Insert -/+ buttons at the top of the screen.
To close the window, tap Close or the upper part of the screen.
75
Advertisement
Table of Contents
