Table of Contents
Advertisement
LFO Modulation
The Modes controls let you set the behavior for each pad's samples in a drum track.
Use the Mute Group field to assign the selected pad to one of the 32 available groups. When pads assigned to the
same mute group receive MIDI notes, the last pad played will silence all other pads in that mute group. A mute group
affects pads within that track only; mute groups do not affect pads in other tracks.
Tip: This feature is useful for programming realistic hi-hats, so only the open or closed hat is heard.
Use the Layer Play selector to determine how multiple samples assigned to the same pad are played:
•
Cycle (Cyc): Each time the pad is played, it will play the next layer's sample. In other words, the samples will
cycle through the layers as follows: 1, 2, 3, 4, 1, 2, 3, 4... etc.
•
Velocity (Vel): The pad will switch between layers depending on how hard you press a pad.
•
Random (Ran): Each time the pad is played, it will play one of its layer's samples at random.
Use the Sample Play selector to determine how much of the sample is played.
•
One Shot: The entire sample will play from start to end. Use this when you want to play short sounds.
•
Note On: The sample will play only as long as the pad is held. This is better for longer samples so you can
control a sound's duration by pressing and holding its corresponding pad.
148
Advertisement
Table of Contents
