Table of Contents
Advertisement
Looping
Use the Enable looping field to select how the resulting samples
can or cannot be looped:
•
Off: The sample will not loop.
•
Forward: You can hold down the pad to cause that
sample to repeat from the Loop Position to the end of the
sample. Release the pad to stop the repeating playback.
•
Reverse: You can hold down the pad to cause that
sample to play in reverse, repeating from the end of the
sample to the Loop Position. Release the pad to stop the
repeating playback.
•
Alternating: You can hold down the pad to cause that
sample to play from the Loop Position to the end of the
sample and then play in reverse until it reaches the Loop
Position again. This will repeat as long as you are holding
the pad down. Release the pad to stop the repeating
playback.
Use the Loop start and Loop end sliders to set the starting and ending points in the sample where the loop will
occur.
Use the Crossfade slider to set the amount of crossfade between the loop end and loop start in seconds.
Use the Crossfade Type field to select Equal Power or Linear crossfade.
Under On completion, check Make current program to load the
completed sampler patch as the current track.
Under Info, the Session Duration field provides an estimate of how
long the auto sampling process will take.
198
Advertisement
Table of Contents
