Table of Contents
Advertisement
Selectors
Selectors show all available options. One of them is always selected. The
selected option is highlighted while the others are dark.
To select an option, tap it.
Buttons
Buttons usually have two states: selected and deselected (active or inactive,
respectively). Some may have more than two states.
To switch between or cycle through a button's states, do either of the
following:
•
Tap it.
•
If it is outlined in red (and is not a mute button), use the data dial or
–/+ buttons.
Checkboxes
Checkboxes have two states: checked and unchecked (enabled or disabled,
respectively).
To check or uncheck a checkbox, tap it.
Tabs
Some modes have buttons at the bottom of the screen that let you cycle
through several similar tabs. For instance, you could view the send level that
is routed to each of four returns—each level is shown on a separate tab. With
each tap, you will move to the next tab, indicated by the squares below it.
To select a tab, tap it. Each time you tap it, it will select the next tab.
39
Advertisement
Table of Contents
