Electric - Akai FORCE User Manual

Electric

The AIR Electric plugin emulates the sound of classic electric pianos.
While viewing any of the tabs listed below, you can quickly enable or
disable the Bell and Noise sounds, as well as the built-in effects
(Tremolo, Tube, Chorus, Delay and Spring Reverb).
When viewing a specific tab, you can enable or disable the sound or
effect by pressing the circle in the upper-right corner of each section.
Pickup / Env
Use this tab to edit the settings for the emulated pickup and the
sound envelope.
Parameter
Pickup Type
Height
Distance
Clip
Keytrack
Envelope Attack
Decay
Release
Peak Length
Keytrack
Description
Type of pickup emulated.
Height of the pickup to the tines.
Distance of the pickup to the tines.
Amount of clipping applied to the signal.
Ties the pickup parameters to the pitch being played.
At higher values, the Distance is increased as the
pitch is increased.
Length of time for the note to reach full volume.
Length of time for the note to reach the sustained
volume.
Length of time for the note to become silent after
being released.
Length of time full volume is held before decaying.
Ties the envelope parameters to the pitch being
played.
At higher values, the envelope time is decreased as
the pitch is increased.
Value Range
Pickup, 0–100% Electro-
Static, 0–100% Electro-
Magnetic
0.0 – 5.0 mm
0.1 – 10.0 mm
0–100%
0–100%
100–0% Hard,
0–100% Soft
100 ms – 20.0 s
100 ms – 5.0 s
3 – 50 ms
0–100%
87