Table of Contents
Advertisement
Send/Return Effects
Send/return effects work in the following way:
1. A pad or drum, keygroup, plugin or audio track sends its audio to a return at a designated send level.
2. That audio is processed by the effects on the return. Each return can have up to four insert effects loaded and
activated.
3. The processed audio is sent to a pair of master outputs (stereo) or a single master output (mono).
You can load send/return effects and set return levels only in the Track Mixer, described below. The rest of this section
describes the different ways to set the desired send levels for pads or tracks.
To load a send/return effect to a return:
1. In the Mixer, press the Master button on the hardware to show the Returns and Master.
2. Tap the Inserts & I/O tab at the bottom of the screen.
3. Tap an insert slot to open the effects window and use it to load or edit effects.
To set the return level:
1. In the Mixer, press the Master button on the hardware to show the Returns and Master.
2. Tap the Volume or Volume & Pan tab in the lower-left corner.
3. In the touchscreen, tap the track that corresponds to the desired return.
4. To adjust the level of the currently selected return, use the data dial or –/+ buttons. Alternatively, use the level
slider in the channel strip. To make finer adjustments, double-tap the track on the screen and adjust the larger
version of the slider that appears.
80
Advertisement
Table of Contents
