Akai FORCE User Manual page 88

Bell / Noise
Use this tab to apply and adjust the settings for the Bell and Noise sounds.
Parameter
Bell Tune
Dry/PU
Volume
Tune Keytrack
Decay
Keytrack
Noise Freq
Random
Mix
Attack
Decay
Keytrack
Setup
Use this tab to adjust general settings for the plugin.
Parameter
Polyphony
Master Volume
Velo Level
Velo Tone
Velo Attack
88
Description
Pitch of the bell sound, in semitones above the root
pitch.
Mix of Dry versus Pickup signal for the bell sound.
Level of the bell sound.
Ties the tuning of the bell sound to the pitches played. 0–100%
How long it takes for the bell sound to dissipate
Ties the amount of bell sound to the pitch being
played.
At negative values, the bell sound is increased as the
pitch increases.
At positive values, the bell sound is increased as the
pitch decreases.
Center frequency of the noise effect
Amount of randomization applied to the noise effect
Level of noise effect present
Length of time for the noise effect to reach full level
Length of time for the noise effect to dissipate
Ties the Freq to the pitch being played.
Description
Number of voices available.
Overall level of the plugin.
Adjusts how much incoming velocity is applied.
Ties the incoming velocity to tone.
At higher values, increased velocity increases tone brightness.
Ties the incoming velocity to the attack envelope.
At higher values, low velocities feature longer attack times.
Value Range
0– 60 semitones
-100% – 0% – +100%
-inf dB – +6.0 dB
100 ms – 7.0 s
-100% – 0% – +100%
200 Hz – 16.0 kHz
0–100%
-inf dB – +6.0 dB
1–50 ms
100 ms – 3.00 s
0–100%
Value Range
1–16 Voices
-inf dB – +6.0 dB
0–100%
0–100%
0–100%