Remove Drain Pump - Maytag 30 Series Service Manual

Electrical Shock Hazard
Disconnect power before servicing.
Replace all parts and panels before
operating.
Failure to do so can result in death or
electrical shock.
1. Unplug washer or disconnect power.
2. Turn off the water supply to the washer.
3. Remove the lower service panel
(See page 4-21).
4. Place a towel or shallow pan below the
pump to catch any water that may be left in
the system.

reMOve Drain PuMP

5.
6.
Drain Pump
4-22
Unscrew the pump filter and pull it out of the
pump. If necessary, use a pair of pliers to
loosen it.
Drain Pump Filter
Disconnect the pump-to-drain hose by
squeezing the ears of the clamp and pulling
the hose off.
nOTe: Take note of the notch on the hose
and the locating notch on the pump that it
aligns with.
Tub To Pump Hose
Tab
Arrow
nOTe: Pump to drain hose clamp may
have a factory installed permanent squeeze
clamp installed. If this is the case, the clamp
must be pried off and replaced with a similar
clamp which requires a special clamp tool.
If this tool is not available a standard worm
gear clamp is sufficient.
Pump to Drain Hose
Notch
On Hose
Notch On
Pump