Lift Washer Top - Maytag 30 Series Service Manual

6. Pull the control panel cover, facia and
display lens off the washer.
7. Depress the clips on the edges of the
display lens on the back side of the control
panel cover. Remove the display lens from
the front of the cover.
8. On PR Models the card reader cover has
two clips on the back side of the control
panel cover that hold it in place. Depress
the clips and remove the cover, along with
the facia, from the front of the control panel
cover.
9. Unclip the two clips from the back side of
the facia and remove the card reader cover
from the front of the facia.
nOTe: To avoid damage, lay a towel, or
another covering, on the washer top and
place removed hardware and tools on the
covering.
TeCH TiPS:
n Machine screws must be used for the facia,
not sheet metal screws.
n In the opening for the card reader is the
cable for a card reader that is now installed
on the control board at the factory.
There is a wire harness in the card reader
n
opening that is connected to the edge of the
UIC used in the manufacturing process only.
It can be left in the control panel or removed
if desired.

LiFT WaSHer TOP

Electrical Shock Hazard
Disconnect power before servicing.
Replace all parts and panels before
operating.
Failure to do so can result in death or
electrical shock.
1. Unplug washer or disconnect power.
2. Turn off the water supply to the washer.
3. Remove the control panel cover
(See page 4-2).
4. Remove two 1/4" hex head screws, one
in each top front corner behind the control
panel cover.
Support Rod
5. Lift the front edge of the washer top to open
it. When it is open all the way it will rest
on the 2 retaining supports attached to the
back of the washer just below the top.
nOTe: If the washer is not level the top may
not be stable to leave in the upright position
without using a support rod.
6. The top has 2 hinges, secured with star
head screws, that are hidden once the top is
closed.
4-3
Two 1/4"
Hex Head
Screws