Remove Lower Service Panel - Maytag 30 Series Service Manual

11. When reassembling the bowl and inner
door trim, position the notch on the rim of
the bowl at the bottom of the door aligned
with the 2 notches on the inner door panel.
12. There is no gasket or sealing material
between the inner door panel and the bowl.
The bellow seats and seals against the
glass of the bowl which should keep water
from reaching this area. This is why the
glass bowl needs to be cleaned periodically
to avoid build up of hair and debris which
will cause water leakage through the door
seal.
reMOve LOWer ServiCe
Electrical Shock Hazard
Disconnect power before servicing.
Replace all parts and panels before
operating.
Failure to do so can result in death or
electrical shock.
1. Unplug washer or disconnect power.
2. Turn off the water supply to the washer.
3. Remove three 1/4" hex head screws under
the lower service panel that secure the
panel to the front of the washer.
4. Slide the lower service panel down and out
to remove it from the washer.
TeCH TiP: It may be easier to reinstall
the lower service panel if the screws are
partially installed first, then slide the lower
service panel onto the screws and force the
panel down and toward the washer to pop it
into place. Secure the three screws tightly.
4-21
PaneL