Remove Rear Panel - Maytag 30 Series Service Manual

Electrical Shock Hazard
Disconnect power before servicing.
Replace all parts and panels before
operating.
Failure to do so can result in death or
electrical shock.
1. Unplug washer or disconnect power.
2. Turn off the water supply to the washer.
3. If they were Installed, remove the 4 plastic
shipping bolt hole covers by lifting the
rounded end to unhook the locking tab from
the slot in the chassis and slide the cover
toward the nearest side panel to release
and remove the covers.

reMOve rear PaneL

4-28
4. Remove the 14 hex head screws that
secure the rear panel to the washer.
5. Pull the bottom edge out and slide the panel
down from behind the lip at the top edge to
remove the panel.