Chemical Dispenser Drawer And Parts; Remove Facia And Control Panel Cover - Maytag 30 Series Service Manual

CHeMiCaL DiSPenSer
DraWer anD ParTS
1. Pull the drawer out as far as it will go and
press the release tab down in the top left
rear corner with a flat blade screwdriver.
2. Pull the drawer out of the washer.
3. Lift the detergent cup insert out of the
detergent drawer for cleaning.
4. Remove the locking tab by unclipping it from
the slots in the top left rear corner. Replace
it by clipping it into the slots.
5. Remove front decorative plate by removing
four T-20 security sheet metal screws.
TeCH TiP:
n The decorative front plate is secured with
sheet metal screws. The facia is secured
with machine screws. Do not interchange
these screws.
n The front of the chemical dispenser drawer
is called the handle, and it can come off if
pulled on too hard. To reinstall the handle
straighten the tabs, hook the top 3 tabs
onto the drawer and rotate the front down to
engage 3 tabs at the bottom.
n If softener fails to dispense properly or
completely, remove the bottom cover of
the dispenser assembly and make sure the
siphon holes are clean.
reMOve FaCia anD
COnTrOL PaneL COver
Electrical Shock Hazard
Disconnect power before servicing.
Replace all parts and panels before
operating.
Failure to do so can result in death or
electrical shock.
1. Unplug washer or disconnect power.
2. Turn off the water supply to the washer.
3. Remove four T-20 security machine screws
from the front of the facia.
4. Remove the chemical dispenser drawer
from the washer.
5. Remove two T-20 security sheet metal
screws, that were hidden by the chemical
dispenser drawer, on the left end of the
control panel.
4-2
Two T-20
Security Screws