Remove User Interface Control (Uic) - Maytag 30 Series Service Manual

reMOve uSer inTerFaCe COnTrOL (uiC)

Electrical Shock Hazard
Disconnect power before servicing.
Replace all parts and panels before
operating.
Failure to do so can result in death or
electrical shock.
1. Unplug washer or disconnect power.
2. Turn off the water supply to the washer.
3. Remove the control panel (See page 4-4).
4. Disconnect all of the wire connectors from
the UIC.
5. Remove the key pad assembly ribbon
connector by gently pulling it out of the
connector GG5 on the board.
6. Remove the 2, number 1, star head screws
from the left end and two 5/16" nuts from
the right end of the UIC.
7. Squeeze the 2 tabs at the left end of the
board together and lift the board up off the
squeeze tabs. Remove the board by sliding
it out of the control board edge connector
mounting bracket.
2 Star Head
Screws
2 Tabs
4-5
Two 5/16"
Nuts
Push Button
Ribbon Cable