Remove Control Panel Bracket - Maytag 30 Series Service Manual

reMOve COnTrOL PaneL BraCkeT

Electrical Shock Hazard
Disconnect power before servicing.
Replace all parts and panels before
operating.
Failure to do so can result in death or
electrical shock.
1. Unplug washer or disconnect power.
2. Turn off the water supply to the washer.
3. Remove the control panel (See page 4-4).
4. Remove three 1/4" hex head screws at each
end of the bracket.
5. Remove two T-20 screws from the control
panel bracket that secure the front and top
of the chemical dispenser.
nOTe: These screws have higher, wider
spaced threads that are made for holding
tightly to plastic. The head shape on these
two screws is also different, a round flat top,
for easy identification.
Three 1/4" Hex
Head Screws
Two T-20
Screws
4-7
6. Disconnect the transformer primary wire
harness connector from near the CCU.
7. Push the free end of wires from the control
panel through the hole in the control panel
bracket and remove the bracket.
Transformer
Wire Harness
Connector
Control Panel
Bracket
CCU
Free End Of Wires
From Coin Meter