Selecting the proper location for your washer
improves performance and minimizes noise
and possible washer "walk." Your washer can
be installed under a custom counter, or in a
basement, laundry room, or recessed area.
Companion appliance location requirements
should also be considered. Proper installation
is your responsibility. You will need
•
A water heater set to deliver 120°F (49°C)
water to the washer.
•
A grounded electrical outlet located within
6 ft (1.8 m) of where the power cord is
attached to the back of the washer.
(See page 2-5).
•
Hot and cold water faucets located within
4 ft (1.2 m) of the hot and cold water fill
valves, and water pressure of 20-100 psi
(137.9-689.6 kPa).
•
A level floor with a maximum slope of 1"
(25 mm) under entire washer. Installing
the washer on soft floor surfaces, such as
carpets or surfaces with foam backing, is
not recommended.
•
A sturdy and solid floor to support the
washer with a total weight (water and load)
of 400 lbs (180 kg).
Do not operate your washer in temperatures
below 32°F (0°C). Some water can remain
in the washer and can cause damage in low
temperatures.
installation clearances
•
The location must be large enough to allow
the washer door to be fully opened.
•
Additional spacing should be considered for
ease of installation and servicing. The door
opens more than 90° and it is not reversible.
•
Additional clearances might be required for
wall, door, and floor moldings.
•
Additional spacing of 1" (25 mm) on all
sides of the washer is recommended to
reduce noise transfer.
•
Companion appliance spacing should also
be considered.
LOCaTiOn reQuireMenTS
Washer dimensions:
1
50
/
"
2
(1282 mm)
Door opens 180° and is not reversible.
A floor drain should be provided under the
bulkhead. Prefabricated bulkheads with
electrical outlets, water inlet lines, and drain
facilities should be used only where local
codes permit.
2-3
27"
(686 mm)
5
44
/
8
(1134 mm)
13
37
/
"
16
(961 mm)
13
28
/
"
16
(732 mm)
"