Remove Aa1 Jumper - Maytag 30 Series Service Manual

Pr Models Only:
iMPOrTanT: Unplug washer or disconnect
power before opening the console to access
connector AA1:
Ë Unplug washer or disconnect power.
Ë Open console, remove and retain plug on
AA1, close console.
Ë Plug in washer or reconnect power.
The washer is now in the set-up mode. The
lower fabric setting key pads and the digital
display are used to set up the controls. The
control can display 4 numbers and/or letters
and a decimal point. These are used to
indicate set-up codes and related code values
available for use in programming the washer.
How to use the key pad to program the
controls
1. The PERM. PRESS button is used to
adjust the values associated with set-up
codes. Pressing and releasing the button
will change the value by increments. Rapid
adjustment is possible by holding the button
down.
2. The DELICATES AND KNITS button
advances the display through the set-up
codes. Pressing the button will advance
to the next available set-up code. Holding
the button down will automatically advance
through the set-up codes at a rate faster
than 1 per second.
3. The QUICK CYCLE button is used to select
or deselect options.

reMOve aa1 JuMPer

3-5
Start Operating Set-Up
Before proceeding, it is worth noting that,
despite all of the options available, an
owner can simply choose to uncrate a new
commercial washer, add appropriate payment
device or OPL Kit as needed and a service
lock for PD models, plug it in, and have a
washer that operates. Washers are preset at
the factory for a 11-minute wash period and 3
rinses (no extra rinse).