22.
Remove the tub clamps by prying them off
with a flat blade screwdriver.
23.
Press the tab on 2 of the 3 guides around
the edge of the tub to release the tub
halves. The 3 guides will assist in re-
aligning the tub halves during reassembly.
24.
Once the halves have been separated
the spin basket can be pulled from the rear
outer tub half.
Alignment
Guide Tab
25.
The bearings and seals are located in the
rear half of the outer tub.
26.
The gasket that seals the two tub halves
together can be removed and replaced in
the channel around the edge of the rear
outer tub. This gasket should be replaced
after separating the outer tub.
27.
When replacing the metal clips, place them
at each location of 2 raised indicators.
28.
Tap the clips onto the tub with a hammer.
29.
There may be more clip locations than
there are clips. Use the extra clips supplied
with the replacement part, or mark the areas
where clips are missing before removal of
the clips.
4-41
Spin Basket
Raised
Indicators
Gasket
Bearing
And Seal