Maytag 30 Series Service Manual page 101

PROBLEM
Washer vibrates
Incorrect water temperature
Display flashing
Water flowing out under
dispenser
1. Remove shipping system.
2. Check leveling legs are locked in place..
3. Check leveling feet are firmly contacting the ground.
4. Check that the washer is level.
5. Check that the bellow has no irregularities or twists.
6. Check air dampers for damage.
7. Check upper support springs for connection to tub and cabinet irregularities.
8. Check that all tub weight bolts are tight and weights are not damaged.
9. Check that metercase bolts are tight.
1. Check that the inlet hoses are connected properly at the back of the washer and
make sure the hoses are connected properly to the dispenser inlet ports.
2. Unplug washer or disconnect power.
3. Check water temperature sensor for an abnormal condition. See the Water
Temperature Sensor section, (See page 5-6).
4. Plug in washer or reconnect power.
5. Verify washer operation by running a Diagnostic Test or any cycle.
1. See Failure/ Error Display Codes, (See page 6-2).
1. Check for detergent build up in dispenser housing and in the dispenser hose to the
outer tub. Make sure the siphon holes in the removable section under the fabric
dispenser are not plugged.
2. Check for clothing article stuck between dispenser fill tube and outer tub.
3. Remove the dispenser drawer and check for build up of detergent under the
drawer.
6-19
POSSIBLE CAUSE / TEST