Maytag 30 Series Service Manual page 49

7. Lift the clip that holds the wires to the pump
and slide the wires down to release them
from the clip.
8. Flip open the lid that covers the wire
connector to the pump motor. Pull the
wire connector off to disconnect it from the
pump.
Cover
9. Use a flat blade screwdriver to lift the right
edge of the rubber pad, on the right pump
support, out of the hole in the washer base.
10. Slide the pump to the right and then lift it
from the base of the washer.
Tab
Wire Connector
Wire Clip
Rubber Pad
11. Disconnect the tub to pump hose by
removing the clamp and pulling the hose off.
nOTe: When reinstalling the tub to pump
hose, align the arrow on the pump with the
tab on the hose.
12. Remove the pump from the washer.
n nOTe: The 2 screws that secure the rubber
mounting piece to the bottom of the pump
support do not need to be removed to
remove the pump assembly.
n nOTe: The filter has a large keyed
shape on the top and a smaller shape on
the bottom which fit into corresponding
sized shapes in the filter housing to
avoid improper filter orientation when it is
reinstalled.
4-23