Changing The Water - Wexiodisk WD-90 DUO Installation And User Manual

Using the dishwasher

4.3.3 Changing the water

Take care to scrape off food residues from the items before putting them in the
dishwasher. If residues are properly scraped off, the water will not need changing
as often, saving time, money and the environment.
The water in the washer tank should be changed daily. More frequent changes of
water are needed if:
• Significant amounts of foam build up in the machine; e.g. if you can see
foam coming out of the waste pipe, or the strainer in the machine's tank is
covered with foam. If this occurs, the water should be changed
immediately.
• A lot of items are washed at certain periods of the day. Schedule water
changes so that a good wash result is achieved over the entire work shift.
Change the water, for instance, after periods when a lot of items have been
washed.
• On checking the wash result you discover any of the problems mentioned
in the chapter "Check the wash result" on page 44 above.
This is what you should do:
1. Run the granule collection programme (see chapter "Wash programs" on
page 39) by pressing the button.
2. Lower the hood with the button for operating the hood (the button at the
very bottom of the panel). Wait until the program has completed its cycle
and the hood has opened.
3. Switch off the machine by pressing the button for switch-on/switch-off. The
hood must be open.
4. Remove the rotating table. Get hold of the spokes in the rotating table,
towards the hub, and pull it straight up towards you. Where necessary,
press on the shaft with the thumb of one hand to get the rotating table to
come off more easily.
WD-90 DUO
46
Rev. 1 (201702)