Using the dishwasher
4.1.2 Before filling the dishwasher with water
Tank
3
The diagram shows the dishwasher's tank
1.
Dividing wall - is perforated and divides the tank into two parts. The part
nearest the front contains the water with granules. The part nearest the
rear of the dishwasher only contains water. In order to facilitate cleaning of
the tank, the dividing wall is provided with a damper that can be opened
when cleaning.
2.
Overflow pipe - works like a plug in the tank's drain and even as an overflow
kit. The overflow pipe sits firmly hooked to a holder in the dividing wall.
3.
Level monitors - sense minimum and maximum water level position during
operation.
Before filling the machine with water prior to the day's work shift, or after a change
of water, a check should be performed to verify the following:
•
The machine has been properly cleaned (See "Cleaning the inside of the
machine" on page 48.).
—
The strainers have been cleaned.
—
The wash arms are not dirty or clogged.
—
The water tank has been rinsed out.
—
The level sensors in the tank are not dirty.
•
Water taps on the water pipe to the machine are open.
•
Granules are only in that part of the tank intended for them.
WD-90 DUO
3
2
30
Rev. 1 (201702)
1
25-4-00-031