Sounds; Cleaning; Repairing And Servicing The Dishwasher; Directions In The Event That The Machine Does Not Work Or Breaks Down - Wexiodisk WD-90 DUO Installation And User Manual

Combination dishwasher
Hide thumbs Also See for WD-90 DUO:
Table of Contents

Advertisement

Safety instructions

2.5.5 Sounds

2.6 Cleaning

STOP
STOP
STOP

2.7 Repairing and servicing the dishwasher

STOP

2.7.1 Directions in the event that the machine does not work or breaks down

During washing using the potwash programmes with granules, the sound level
can become high (see Sound levels table in chapter entitled Technical data in In-
stallation and User Manual). Hearing protection should therefore be used when
running potwash programmes with granules.
The temperature of the water in the tank is approximately 55–65°C, and the water
contains detergent. Be careful when draining and cleaning the tank. Use protec-
tive gloves.
Pressure washers must not be used for cleaning the machine. If water from a
pressure washer is directed at the electrical cabinet, it may penetrate the cabinet
and damage the electrical equipment, thereby impacting on safety.
To meet current regulations, electrical components of approved enclosure class
are used. No enclosure class is designed to withstand high pressure.
The machine exterior may not be washed down with a pressure washer, nor
should the machine be washed down using a hose pipe (applies mainly to con-
nection points). Water may penetrate the electrical cabinet and control panel and
damage the equipment, thereby impacting on safety.
If floors are cleaned using high-pressure equipment, water may splash up under
the machine and damage the components. These have not been designed to
withstand being washed with water at high pressures. Never use a pressure
washer to clean the floor within one metre of the machine without the special pro-
tective covers that are available to prevent splashing. Problems with splashing
can also occur when using an ordinary hose pipe.
Make sure the machine is non-live before opening the electrical cabinet. Turn off
the power at the mains switch. Avoid touching hot pipes and the booster heater.
If the machine breaks down, e.g. a pipe breaks or the tank leaks, etc., turn off the
power at the safety switch. Call a service engineer.
If the machine has to be stopped while washing is in progress, e.g. because you
selected the wrong programme, something happened with the basket or the items
being washed when washing was under way, etc., press the dishwasher's On/Off
button. If you need to open the hood, the dishwasher must be re-started (see
"Cancelling a wash program and stopping the machine" on page 41).
WD-90 DUO
9
Rev. 1 (201702)

Advertisement

Table of Contents
loading

Table of Contents