Cleaning The Inside Of The Machine - Wexiodisk WD-90 DUO Installation And User Manual

Using the dishwasher

4.3.4 Cleaning the inside of the machine

9. Clean the level pipe (1) and check that the foam separator (2) is not locked
in position but can move backwards and forwards.
2
10. Refit the level pipe. Make sure the rubber sleeve (3) achieves a good seal
with the bottom of the tank.
11. Refit the cover plates and the strainer.
12. Refit the rotating table. Make sure the screw heads on the shaft plate which
supports the rotating table end up in the holes on the bottom of the rotating
table's hub.
13. Now the machine can be filled with water, see "Filling with water" on
page 38.
The machine should be cleaned at least once a day when in normal operation.
Once a week, more thorough cleaning of the machine should be carried out,
where the rinse pipes and granules are also properly cleaned and a check per-
formed on the amount of granules.
Make sure you adhere to the following when cleaning the machine:
• Do NOT use steel wool as this can cause rust to form on the machine.
• Pressure washers can damage the machine and must NOT be used for
cleaning purposes. Never use a pressure washer to clean the floor within
one metre of the machine without the protective covers that are available
to prevent splashing. The supplier cannot be held liable for any faults
caused by the use of pressure washers on the machine and any such use
will invalidate the warranty.
This is what you should do:
1. Open the hood – press the button for operating the hood (the button at the
very bottom of the panel).
2. Remove the rotating table from the machine. Get hold of the spokes in the
rotating table, towards the hub, and pull it straight up towards you. Where
necessary, press on the shaft with the thumb of one hand to get the rotating
table to come off more easily.
3. Clean and rinse off the rotating table with water.
WD-90 DUO
1
3
48
Rev. 1 (201702)
25-4-03-005