Safety Instructions; General Information; Transport; Installation - Wexiodisk WD-90 DUO Installation And User Manual

Safety instructions

2. Safety instructions

2.1 General information

STOP
STOP

2.2 Transport

STOP

2.3 Installation

STOP
The machine is CE marked, which means that it complies with the requirements
of the EU machinery directive with regard to product safety. Product safety means
that the design of the machine will prevent personal injury or damage to property.
Modifying the equipment without the approval of the manufacturer will invalidate
the manufacturer's product liability.
To further improve safety during installation, operation and servicing, the operator
and the personnel responsible for installing and servicing the machine should
read the safety instructions carefully.
Switch off the dishwasher immediately in the event of a fault or malfunction. The
machine must only be repaired by trained engineers. The regular checks de-
scribed in the installation and user manual must be carried out in accordance with
the instructions. The machine must be serviced by personnel authorised for this
purpose by the manufacturer. Use original spare parts. Contact an authorised
service company to draw up a programme of preventative care and maintenance.
Hazardous situations may arise if the instructions above are not followed.
Before the machine enters service, ensure that the staff are given the necessary
training in handling and looking after the machine.
Handle the machine with care during unloading and transport; there is a risk of it
tipping over.
This symbol on a machine component warns of the presence of electrical voltage.
The component may only be disconnected by a qualified electrician. Make sure
the machine is non-live (turn off the power at the safety switch) before any work
is performed on the machine. The electronics in the machine is sensitive to elec-
trostatic discharge (ESD), which is why a static electricity wristband must be used
when handling the electronics.
The dishwasher's electrical cabinet is located within the cover plate on the right-
hand side of the dishwasher. The cover plate creates a seal against the electrical
cabinet and serves as a lid for it. There are pumps and other live components
within the two other cover plates on the bottom section of the dishwasher. The
cover plates may therefore not be removed by anyone other than a service engi-
neer or a qualified electrician.
WD-90 DUO
6
Rev. 1 (201702)