Installation - Wexiodisk WD-90 DUO Installation And User Manual

Installation

3.6 Installation
Before positioning the machine at its intended location, make sure you adhere to
the following procedure:
• Check that the overheating protection device has been reset.
• Check that the fuse for the element in the booster heater and tank, FU21/
42, is off (it is in the electrical cabinet inside the right-hand side panel).
• Remove the protective plastic on the sides which are to be stood against a
wall.
• Undo the detergent hose on the back of the machine (See "Detergent
dosage" on page 22.). Hang the hose up so that it can be easily accessed
by the detergent supplier.
• Move the machine into position. There must be a gap of at least 100 mm
between the dishwasher and the walls.
• Adjust the dishwasher to ensure it is standing level – put a spirit level
against the dishwasher rib. Check along three sides (front, right and left) of
the machine that it is standing straight. Adjust the height using the
dishwasher's legs.
• Check that the gap between the hood and lower part is approximately 5 mm
all around the rib of the machine.
WD-90 DUO
13
Rev. 1 (201702)
25-4-00-014