Normal Wash Programs - Wexiodisk WD-90 DUO Installation And User Manual

Using the dishwasher
Once the dishwasher has finished the wash, the hood goes up and you can insert
a new basket. Between washes, the last wash programme run (for both potwash
and normal wash) is shown on the display (1) and the last normal wash pro-
gramme run is active, i.e. if the button for operating the hood (9) is pressed, it is
this programme that starts. If another wash programme other than the active one
should be run, this must be selected with the help of one of the programme but-
tons (2 - 4). Which programme is active is shown by a shaded box behind the ac-
tual programme shown in the display and the LED next to the programme button
for the active programme is lit.
For example:
The following message is displayed after potwash programme P1 (potwash with
granules) has been run:
NORMAL WASH P1 █
POTWASH WITH
GRANULES P1 [ ]
CLOSE HOOD
In this case, the normal wash programme P1 is active in the dishwasher and this
is also indicated in the shaded box behind the message NORMAL WASH P1 by
the fact that the LED in front of the programme selection button 2 is lit. Press the
button for hood operation (9) and the normal wash programme P1 starts.
If no wash has been performed since the machine was switched on, program P1
is displayed for both normal wash and potwash.
If another programme other than the one indicated in the display needs to be run,
select the programme as per the description under the headings Normal wash
programme and Potwash programme below. The selected programme always
starts by pressing the button for hood operation (9).
During washing, in standby mode, on start-up and switch-off, etc., the status of
the machine is shown in plain text on the display.
It is important that the correct wash program is selected for the type of items in
question.

Normal wash programs

A normal wash program is used for items such as, e.g. glass, crockery and cut-
lery. Three different normal wash programs can be selected with the button (2) by
pressing it once, twice or three times. The selected program is shown on the dis-
play (1).
• Pressing the button once selects normal wash program 1 (P1).
• Pressing the button twice selects normal wash program 2 (P2).
• Pressing the button three times selects normal wash program 3 (P3).
• Pressing the button four times selects program P0, which results in the
machine being set to standby mode for washing.
The difference between the three normal wash programs is the time it takes for
the actual wash cycle to complete. For the total time used by the relevant normal
wash program, see "Technical data" on page 63.
WD-90 DUO
40
Rev. 1 (201702)