Fitting The Condensation Unit - Wexiodisk WD-90 DUO Installation And User Manual

Installation

3.6.1 Fitting the condensation unit

On delivery of dishwashers with condensing unit, the condensing unit is folded
down over the hood and secured with protective transport plates.
NB: The dishwasher should be adjusted so that it is standing level when
assembly of the condensing unit starts
1. Undo and remove the upper back panel at the rear of the dishwasher.
2. Loosen and remove the screws (c) that hold the protective transport plate
(b) against the condensing unit (a).
3. Loosen and remove the screws (d) and nuts that hold the protective
transport plate against the brackets at the back of the dishwasher and
remove the protective transport plate (b).
Possibly need to loosen the contact (JM15) on the power cable to the
condensing unit.
a
c
4. Lift into upright position the condensing unit (weight approximately 25 kg)
so that it can be attached to the brackets (item no. 5 in the diagram below)
at the back of the dishwasher.
The condensing units should not be pulled but lifted into place so that the
sunken seal high up on the back of the dishwasher is not damaged or
warped.
5. Attach the condensing unit to the brackets (item no. 5 in the diagram below)
to the dishwasher with the help of the screws which were removed
previously.
Check that the condensing unit is perfectly level.
Tighten the screws.
WD-90 DUO
c
d
b
d
14
Rev. 1 (201702)
b
25-4-01-008