Checking The Hood's Anti-Crushing System; Longer Periods Without Use; Periods Without Use Of Up To A Week - Wexiodisk WD-90 DUO Installation And User Manual

Using the dishwasher

4.3.9 Checking the hood's anti-crushing system

4.3.10 Longer periods without use

Operation of the hood's anti-crushing system must be checked once a month. It
should also be checked by a service engineer whenever the machine is serviced.
1. Open the hood. Press the button for operating the hood (at the very bottom
of the panel).
2. Hold a piece of wood or similar against the edge on the lower part of the
machine.
3. Press the button for operating the hood (at the very bottom of the panel).
4. Once the hood has gone down far enough to reach the piece of wood and
start pressing on it, the hood should reverse and return to its open position.
The sensitivity of the anti-crushing system may need adjusting from time to time.
If so, a service engineer must be called.

Periods without use of up to a week

• The machine is cleaned as for weekly cleaning (see "Cleaning the inside of
the machine" on page 48 and "Cleaning the exterior" on page 53).
• The granules are placed in a bucket containing water mixed with soaking
agent or a suitable cleaning agent.
• Carefully wash the granules – stir the granules round and remove any food
residues or detritus.
• Leave the granules in the water for the period the machine is not in use.
• Alternatively, the granules can be cleaned and then put in a freezer for this
period.
• Rinse the granules with clean water before pouring them back into the
machine.
WD-90 DUO
55
Rev. 1 (201702)
25-4-05-001