Bleeding The Booster Pump; Bleeding The Hood Lifting Cylinder - Wexiodisk WD-90 DUO Installation And User Manual

Installation

3.6.3 Bleeding the booster pump

3.6.4 Bleeding the hood lifting cylinder

Bleeding the hood lifting cylinder and booster pump and must be done when the
dishwasher is started up. Start by lifting the pump. Proceed as follows:
1. Open the water connection to the dishwasher and wait until the
dishwasher's break tank has filled with water.
2. Loosen the screw in the ventilation hole on the booster pump and release
any air. When water starts to run out of the ventilation hole, the screw is
tightened.
3. Then bleed the hood lifting cylinder, see below.
Bleeding of the hood lifting cylinder is done when the dishwasher is started up,
after the booster pump has been bled. Proceed as follows:
1. Start the dishwasher.
2. Select programme P0 (see "Wash programs" on page 39).
3. Open the hood.
4. The dishwasher alarm may sound and the hood stops opening. Reset then
the alarm and continue.
WD-90 DUO
19
Rev. 1 (201702)
25-4-05-003