Washing; Filling With Water - Wexiodisk WD-90 DUO Installation And User Manual

Using the dishwasher

4.2 Washing

4.2.1 Filling with water

4.2.2 Washing
Before washing can be started, the dishwasher tank must be filled with water and
the detergent mixed. The points below must be followed when the dishwasher
has no water in it.
When filling the machine with water, you should not have any items in the ma-
chine. Water which is hotter than for normal washing is flushed into the washing
compartment when the machine is being filled. This can result in food residue get-
ting burnt onto any items in the machine, giving a poorer wash result.
This is what you should do:
1. Carry out the recommended checks
before washing commences, see "Before filling the dishwasher with water"
on page 30.
2. Start the machine
by pressing the ON/OFF button. The dishwasher's hood opens.
3. Select a wash program.
For the best program to select, see "Wash programs" on page 39.
4. Press the button for operating the hood (the button at the very bottom
of the panel). Wait until the following message is displayed;
MACHINE IS READY
FOR WASH
OPEN THE HOOD
AND INSERT GOODS
5. Open the hood with the button for operating the hood (the button at the
very bottom of the panel).
6. The machine is ready to be used!
The dishwasher's tank must be filled with water (see above "Filling with water" on
page 38) before washing can begin.
Take care to select the correct program for the items which are to be washed.
This is what you should do:
1. Put the items to be washed in the machine.
For information on what you need to remember before washing and when
positioning items in the basket, see "Before washing" on page 27".
2. Select a wash program.
Select the desired wash program by pressing one of the buttons for
program selection, see "Wash programs" on page 39.
WD-90 DUO
38
Rev. 1 (201702)