Set Up Downloading - Pyronix Enforcer 32-WE Programming And Installation Manual

Diagnostics Programming: View Inputs.
1. Press or to scroll to 'DIAGNOSTICS'. Press .
2. 'View PSUs' will be displayed. Press .
3. 'View Inputs' will be displayed. Press .
4. 'Endstation Inputs' will be displayed. To view the Endstation Inputs
(the two inputs on the I/O board) press . The status will be
displayed. Press  again to view the resistance values. Press
to return to the sub-menu.
5. Repeat the above for the sub-menu's 'Wireless Inputs', and 'ZEM
Inputs' (selecting the address first). Press to return to the sub-
menu.
Diagnostics Programming: View Wireless Device Status.
1. Press or to scroll to 'DIAGNOSTICS'. Press .
2. 'View PSUs' will be displayed. Press .
3. 'View Inputs' will be displayed. Press .
4. 'View Wireless Device Status' will be displayed. Press .
5. 'Signal Strength' will be displayed, press , or  to jump to
'Battery'.
6. 'Inputs' will be displayed in the Signal Strength Menu, press .
7. 'Please Wait' will be displayed and a countdown of 300 will start.
This process will take a few minutes. The display will then show
the signal strength, to show a detailed signal strength view press
 on this screen. Use [ or ] to scroll through each input (or
alternatively enter the input number). Press  to exit.
8. 'Bells' will be displayed. Repeat the above for the Bell signal
strength. Press to return to the sub-menu.
9. 'Battery' will be displayed. press  to view the battery status of
all wireless inputs and bells. Repeat as mentioned above. Press
to return to the Engineer menu.

4.21 Set Up Downloading

The Enforcer 32-WE system has uploading and downloading capability. The Enforcer 32-WE 'InSite'
upload/ download software allows the monitoring of the status of each input, alter programming, and
review the logs. This software is available to download from www.pyronix.com under 'downloads'.
When this section refers to 'dials the software', this means the PC that the software is installed.
4.21.1 Download By
A download from the Enforcer 32-WE to the PC can be done either by RS232 (direct connection -
see page: 38) or Modem (remote dial in connection - see page 38).
4.21.2 Security Mode
When creating a customer in the 'InSite' software, it is important that the Enforcer 32-WE
telephone number is programmed both in the software and the Enforcer 32-WE (in this menu).
[0] Auto Answer: Allows the software to dial into the Enforcer 32-WE at any time.
[1] Panel Dials: This does not allow the software to dial into the Enforcer 32-WE at all. All
modes allow the Enforcer 32-WE to dial the software without restriction. At any time, the
Enforcer 32-WE can be forced to dial the software by entering the Master Manager menu and
selecting 'DIAL OUT MENU'.
[2] Dial Back: When dialing the Enforcer 32-WE, click the 'Dial Customer' option in the software
Enforcer Programming Manual
Page: 28
DIAGNOSTICS?
View Inputs?
Endstation
Inputs?
00
DIAGNOSTICS?
View Wirless
Device Status?
Signal Strength?
Inputs?
Input [01]
Excellent [100]
Battery?
Input [01]
Good