Dust Seal And Bearing Replacement - Suzuki RM-Z250 Service Manual

16-4 FRONT AND REAR WHEELS
WHEEL RIM
• Measure the wheel rim runout with the dial gauge.
• If the runout exceeds the limit, replace the bearings or wheel.
 Service Limit: 2.0 mm (0.08 in) ... axial and radial
 09900-20607: Dial gauge
09900-20701: Dial gauge chuck
WHEEL BEARING
• Turn the inner race by finger and inspect it for smooth move-
ment.
• Inspect for bearing damage.
• If any defects are found, replace the bearing with a new one.

DUST SEAL AND BEARING REPLACEMENT

• Remove the dust seals 1 with the special tool.

The removed dust seals 1 must be replaced with new
ones.
 09913-50121: Oil seal remover
• Remove the bearing 2 with the special tool.
• Remove the spacer 3 and bearing 2 with the special tool.

The removed bearings 2 must be replaced with new
ones.
 09921-20240: Bearing remover set