Suzuki RM-Z250 Service Manual page 173

10-16 TRANSMISSION AND CRANKSHAFT
• Apply engine oil to the following parts: driveshaft, countershaft,
transmission gears, bearings.
• Install the driveshaft 2 and countershaft 3 with gears
installed.
NOTE:
* Install the washers A, B located in both ends of the driveshaft
positively.
* Install the washer C located in end of the countershaft 3 pos-
itively
• Install the gearshift forks (4, 5, 6) as shown.
• Install the gearshift cam 7 and gearshift fork shafts 8.
NOTE:
Turn the gearshift cam to the neutral position and confirm that
the driveshaft and countershaft turn without resistance.
• Install the oil reed valve 9.
4 For 5th driven gear
5 For sliding dog
6 For 3rd/4th drive gear