Wiring Harness Routing - Suzuki RM-Z250 Service Manual

20-18 SERVICING INFORMATION

WIRING HARNESS ROUTING

1 Engine stop switch lead wire
2 Handlebars
3 IAT sensor
Bind the engine stop switch lead wire and hot
*1
starter cable with the clamp.
Clamp the IAT sensor lead wire at the gray tap-
ing. Do not clamp IAT sensor lead wire at the
*2
square part of pipe of seat rail. Set the tip of
the clamp downward.
*1
Clamp the wiring harness and fuel pump lead wire at
*3
the gray taping. Set the tip of the clamp inside.
Bind the magneto lead wire and GP switch lead
*4 wire with the clamp. Set the lock part of clamp out-
side and tip of clamp backward.
Bind the magneto lead wire, GP switch lead wire
and overflow hose with the clamp. Pass the over-
*5
flow hose inside of left engine mounting lower
bracket. Set the tip of the clamp inside.
Do not slack the GP switch lead wire at this posi-
*6
tion.
Pass the GP switch lead wire inside of magneto
*7
lead wire.
*3
*6 *6
*4
*5
*7
*2