• Install the engine sprocket 1 and snap ring 2.
* Replace the snap ring 2 with a new one.
* Seat the snap ring 2 in the groove and locate its end
as shown in the illustration.
09900-06107: Snap ring remover (Open type)
• Reassemble the drive chain clip so the slit end faces opposite
the direction of rotation.
• Install the front chain guide plate 3 and engine sprocket
cover 4.
When installing the front chain guide plate 3, pay
attention to its direction.
• Tighten the engine sprocket cover bolts 5 to the specified
torque.
Engine sprocket cover bolt: 11 N·m (1.1 kgf-m, 8.0 lbf-ft)
• Install the gearshift lever 6 in the correct position.
ENGINE REMOVAL AND INSTALLATION 5-7
Direction of travel
Thrust
Sharp
edge
Upper side