Set The Cursor Measurement - Tenma 72-2650 Operating Manual

FallTime: The time of waveform amplitude falling from
90% to 10%.
+Width: The width of positive pulse at amplitude of 50%.
-Width: The width of negative pulse at amplitude of 50%.
Delay (rising edge): The delay time between rising
edges. Delay (falling edge): the
delay time between falling edges.
+Duty: The specific value of positive pulse width and
cycle.
-Duty: The specific value of negative pulse width and
cycle.

2.9 Set The Cursor Measurement

The user can press the CURSOR button to enable the
cursor measurement function for 72-2650/72-10510/
72-8225A /72-8705A/72-8710A DSO, where the location
of the CURSOR button can be found on the figure below.
46
72-2650/72-10510/72-8225A /72-8705A/72-8710A user manual
72-2650DSO (Top),
72-10510/72-8225A/72-8705A/
72-8710A DSO (Down)
Figure 2-25 Function Key of
Sampling System (CURSOR)
72-2650/72-10510/72-8225A /72-8705A/72-8710A
DSO supports 3 different types of cursor measurements.
Volt: Voltage (Vertical System)
Time: Time (Horizontal System)
Track: Volt and Time working at the same time.
At the Volt cursor measurement, the user should be able