Cursor Measurement - Tenma 72-8710 Operating Manual

Table 2-29
Function/Measurement
Previous Return to the previous page
Fall Select to return to the parameter
measurement display menu and replace
the original parameter in that position
+ Width
Ditto
- Width Ditto
2 3
Next ( / ) Turn page
Table 2-30
Function/Measurement
Previous
Return to the previous page
Delay Select to enter the delay option menu
(as shown in Table 2-31)
Select to return to the parameter
+Duty
measurement display menu and
replace the original parameter in that
position
- Duty Ditto
Next (3/3)
Return to page 1 (as shown in Table 2-28)
60
Explanatory Note
Explanatory Note
Table 2-31
Function Menu Setup
From(Channel) CH1/CH2/MATH
To(Channel) CH1/CH2/MATH
OK

Cursor Measurement

Press [CURSOR] to display the measurement cursor and cursor menu,
then adjust the cursor position by turning the multifunction control knob.
As shown in the figure below, [CURSOR] in the MENU control zone is
the function key for cursor measurement.
Figure 2-28 Function key for the sampling system (cursor)
DSO Series User Ma nual
Explanatory Note
Select the reference channel
Select the channel to be measured
Select to return to the parameter
measurement display menu and
replace the original parameter in
that position