Waveform Storage Menu - Tenma 72-2650 Operating Manual

Press the Storage button and you will see the
following menu:
Table 2-13 Waveform Storage Menu
Function
Settings Description
Menu
Type (F1)
Wave Select to store an acquired waveform
Select waveforms from CH1 channel
CH1
to be saved
Source(F2)
Select waveforms from CH2 channel
CH2
to be saved
Destination (Position of the internal
memory) where the waveform will be
saved. There are 20 sets of internal
Dest (@) 1～20
memory available to storage
waveform navigated by the
multipurpose knob.
Store waveform
Save
Next page
Go to the next page
1/2
Press F2 to select the waveform source to be saved.
36
72-2650/72-10510/72-8225A /72-8705A/72-8710A user manual
Use the multi-purpose knob to select the storage memory
destination.
Press F4 to store the waveform.
Attention:
Any storage of the waveform will overwrite previous
memory space in the same memory location.
To load a waveform from the internal memory of the
DSO, please refer to Chapter 2 of this user manual.
The below steps will guide you to store a waveform
to a USB device:
Insert a USB disk into the "USB Host" interface. If
the USB is connected successfully, you should see the
system message "USB device install successful"
shown on the screen.
Press the Storage button and you will see the following
menu: