Pass/Fail Function Menu; Waveform Recorder Operation Menu - Tenma 72-2650 Operating Manual

72-2650/72-10510/72-8225A /72-8705A/72-8710A user manual
menu below.
Table 2-21 Waveform Recorder Operation Menu
Function
Settings Description
Menu
Press to start waveform recording;
Record (F1)
the number waveform being
recorded is show on the screen.
RePlay (F2)
Press to start waveform replay.
Stop(F3) Press to stop waveform recording.
Go back to previous menu
Return (F4)
One of the very useful functions for the 72-2650/
72-10510/72-8225A /72-8705A/72-8710A DSO is the
pass/fail detection function.You can create a template
of pixels area to compare with the input signal.
The user can also select the output condition for the logical
result between the templates of area and the input source.
You can enable the PASS/FAIL function by pressing
F1 on the PASS/FAIL function menu. After turning on
this function, you can see the total number of waveforms
being processed, the number of waveforms that pass and
the number of waveforms that fail on the LCD screen.
Table 2-22 Pass/Fail function menu
Function
Settings Description
Menu
ON Press to turn on the PASS/FAIL function
Status (F1)
OFF Press to turn off the PASS/FAIL function
Select CH1 as the detection signal source
CH1
Select CH2 as the detection signal source
CH2
Select MATH result as the detection
MATH
signal source
Source (F2)
Select RefA as the detection signal
RefA
source
Select RefB as the detection signal
RefB
source
Select the logical result as input signal
Pass
within the template of pixels area
Select the logical result as input signal
Fail
Output (F3)
outside of the template of pixels area
Same as Pass output condition; stop
Pass/Halt
once detected
Same as Fail output condition; stop
Fail/Halt
once detected
43